The Buttons and Switches of Your IonizeMe Classic Ionic Foot Detox System

The Buttons and Switches of Your IonizeMe Classic Ionic Foot Detox System - HEALTHandMED

Using the Buttons and Switches on the IonizeMe Classic Ionic Detox Foot Bath

If you own the IonizeMe Classic, you’ve undoubtedly discovered that there are quite a few buttons and switches that come with it. Fortunately, it’s easy to use the system once you’ve learned what each of these switches and buttons do.

The Volt Switch

On the back of the machine, there is a switch that toggles between 110/115 volts and 220/230 volts. Some countries such as the U.S. and Canada run on 120 volt, 60 cycles per second (60 hertz), while most of the world runs on 220/230 volt, 50 cycles per second (50 hertz). If the switch is not in the right position for your country, then you can use a small flat headed screwdriver to flip the switch to the correct position.

Power Switch

When you’re ready to start your foot bath treatment, you’ll need to flip the power switch in the rear of the foot bath so that the “1” is depressed instead of the “0”.

RELATED: Troubleshooting your Ionic Foot Detox System with Wrist Strap

On/Off Button and MODE Button (FIR belt only)

If the FIR belt is to be used, press the On/Off button on top of the unit. This will cause the L to light up red. This means that the FIR belt is set to the low intensity. Press the “MODE” button to change between low, medium and high intensity.

Plus “+”, Minus “-” and ESC Buttons

Most detox sessions last 30 minutes. If less time is needed, then the button may be used to change the “TIME” to anywhere between 10 and 30 minutes. If you press the ESC button during the session, the timer resets to 30. The ESC also acts as a back button to return to the main menu after accessing the Total Sessions and Time Log functions (see below).

ENT Button

The ENT button is essentially the “start” button that starts each Ionic Detox session. It’s also used as an ENTER key while in the Total Sessions and Time Log functions as mentioned below.

Number Buttons (Total Sessions and Time Log Functions)

To examine the total sessions and time log, press 1 and ENT on the keypad simultaneously while also turning on the power switch. The top line shows the total operating time in minutes and the bottom line shows the total number of times the machine has been used for 10 minutes or more. Press ESC on the keypad to return to the main menu.

To erase the total sessions and time log, press 2 and ENT on the keypad simultaneously while also turning on the power switch. The screen will say Clear Contents. Then enter the password — the default password is 666666 — and press ENT on the keypad. If the password is correct, the screen will say Process: OK and Mins=00000. Press ESC to return to the main menu.

To create a new password, press 3 and ENT on the keypad simultaneously while also turning on the power switch. The screen will say Change Password. First, input the password. Then press ENT. If the password was correct, the screen will say, New PAS. Be sure and write down the password for future reference.